PTFE Corrugated Hose Kink Resistance Braided Factory | BESTEFLON
Besteflon use advanced corrugated molding process, after a long time of use, not easy to produce cracks, safer use, longer life.
The objective in the pipeline design, the assembly can achieve the following purposes: absorbing vibration, suppressing the noise transmitted by rigid pipe, adapting to reciprocating and bending motion, and adjusting or correcting the micro-vibration. The pitch of the hose can be varied to meet the performance requirements rating in terms of flexibility and pressure.
The purpose of the stainless steel braid is to prevent elongation. The braided fabric is made of stainless steel wire, and the braiding tension is generated by the braiding pressure to provide radial and axial constraints. The multi-braided assembly adapts to higher pressures.
Medium wall, spiral-corrugated white/translucent PTFE
Single stainless steel 304/316 wire braiding
From -65 to +260 ºC(-85°F---500°F)
Press-fitted couplings in any design and material type
Aging / oxidation / discoloration resistance
Suitable for pressure and vacuum
Suitable for high mechanical strength
|Specification:||3/16'' to 2 ''|
|Inside hose color:||milky white/translucent|
|Wire braided:||304/316 stainless steel wire braided|
|Appliecation:||Chemical/Machinery equipment//Compressed gas/Fuel and lubricant handling/Steam transfer/Hydraulic systems|
Convoluted Hose Range
|No.||Inner diameter||Outer diameter||Tube Wall
|Working pressure||Burst pressure||Minimum bending radius||Specification||sleeve size|
* Customer-specific products may be discussed with us for detailed.
How to cut the PTFE hose to avoid damaging the pipe?
In order to achieve the above purpose, the utility model provides the following technical scheme: a cutting device for the manufacture of polytetrafluoroethylene pipes, including a worktable, the upper surface of the worktable is provided with a bracket, the center of the lower surface of the support is fixedly connected with a hydraulic cylinder, the output shaft of the hydraulic cylinder is fixedly connected with a cutter, and the center of the upper surface of the worktable is provided with a first groove The first groove is located directly below the cutter, one side of the first groove is provided with a second groove, the second groove is provided with a first plate body, the outer wall of the first plate body is uniformly installed with a first slide block, the first sliding block slides in the second groove, one side of the first plate body away from the first groove is fixedly connected with a rocker The front surface of the worktable is provided with a third groove, the rocker is located in the third groove, the first groove is provided with a limit plate, one side of the limit plate far away from the first groove is fixedly connected with a bearing, the back surface of the worktable is provided with a threaded through hole, and the screw rod is connected with the thread in the threaded through hole.cut the PTFE hose
We offer the usual packing as follows
1、Nylon bag or poly bag
3、Plastic pallet or plywood pallet
Customized Packaging is charged
3、Other customized packaging also available